Pricing is for Labor Only - Parts & Materials NOT Included
This is a list of some basic costs for common gunsmithing services we provide. Due to the wide variations in firearms, these prices should be a general guide, and specific pricing will be discussed after your particular firearm has been evaluated.
- Troubleshooting and function test $100 shop rate
- General machining service (excluding parts) $100/hr
- Completely disassemble (clean and lubricate) $80–$250
- Thread rifle barrel for flash hider or suppressor $150
- Thread pistol barrel $150–$160
- Drill & Tap receiver or barrel for sights $45 Per hole
- Cut & Re-crown barrels $130
- Pin & Weld muzzle device $100
- Bore sighting $40
- Install night sights $50–$95
- Scope Mounting gun drilled & Tapped already $70
- Trigger jobs $70–$180
- Straighten Crane on Revolver $80–$100
- INSTALL FRONT SIGHT RAMP
– Sweat-on type $70-$100
– Screw-on type (including drill & tap) $70-$90
– Band type Hourly Rate - Shorten shotgun or Rifle barrels for defense $80–$130
- Install Sako or M16 extractor $225
- Lap Bolt Lugs $80
- Blue Print Action Receiver $380
- Weld on New Bolt Handle $225
- Fit new recoil pad $90–$100
- Install pre-threaded / short chambered barrel $250
- Check head space $40
- Raising dent in shotgun barrel or magazine tube (not including bluing) $70–$90
- Polish chamber/bore $70–$90
- Tune 1911’s $120–$190
- Stock work refinishing (does not include any shaping) $120–$180
- INLETTING stock for bottom metal $160 – $240 depending on how much fitting is needed
- Metal finishing (Parkerizing and cold blue) Abrasive / bead blast / wire wheel (matte) finish $160–$200
- Deluxe Finish: Same as above followed with #240 and #400 grit polish with all screw holes and corners protected and square Handgun $190–$270
- Case hardening parts $80–$130
- Chamber cast $70–$80
- Remove stuck fired case from chamber Hourly rate
- Remove live round from chamber Hourly rate
- Remove fouling from barrel Hourly rate + Materials
- Open / Modify choke – Per barrel or tube, non-plated bores $100–$140
- Install / Screw-In Choke (plus tubes) Win-Choke (non-plated bore) $200
- Written Appraisals $50